When it comes to wiring up any kind of electrical device, having a clear understanding of the wiring diagram is essential. This is especially true when it comes to Nilight rocker switches. For those unfamiliar, Nilight is a popular brand of switch that is used in a variety of applications. The tricky part is deciphering the wiring diagrams and connecting them correctly.
Components of a Rocker Switch
Rocker switches are comprised of three main components, two large pieces of plastic that make up the body of the switch, and a third, smaller piece of plastic that serves as the rocker arm. The two large pieces of plastic are connected by a hinge and are referred to as the left and right sides of the switch. The smaller piece of plastic is connected to the hinge, and when the switch is pushed, it rocks back and forth, allowing the electrical current to flow.
Understanding the Wiring Diagram
Each Nilight rocker switch has a wiring diagram that can be found on the back of the packaging. The wiring diagram will provide all of the information needed to correctly wire the switch. Each diagram is divided into three sections, power, ground, and signal. The power section will indicate which wires will carry the electrical current, while the ground section will indicate which wires will be used to ground the device. The signal section will indicate which wires will be used to control the device.
Once the wiring diagram is understood, all the necessary components must be connected to the switch. This includes connecting the wires to the power, ground, and signal terminals of the switch. It is important to ensure that the wires are connected securely to the switch, as any loose connections could cause a short circuit or other electrical issues. It is also important to ensure that the switch is properly grounded, as this will provide additional safety.
Conclusion
Understanding Nilight rocker switch wiring diagrams is essential for anyone wanting to install a switch. By studying the wiring diagram, it is possible to determine which wires need to be connected, and where they should be connected. Once all of the necessary components have been connected securely, the switch should be tested to ensure that it is functioning as intended.
